![]() +Either use the arrow keys for X/Y movement and Page Up/Down for Z direction It is advised that this point still leaves space of 50-70 mm to the edges. The first thing to do is to move the arm to the zero point on the X and Y axis.The vacuum cleaner should be connected to the tube on Y+ side of the CNC machine (see below) and the tube of it fixed to the drill head (see 3 above). ![]() ++Works similar to a ratchet ("Ratsche"). ++This is followed by turning without the button pressed and pushing it again. ++This gets done by pressing the red button to release the handle and turning the lever. Adjust and fix the milling head with the "Schnellspannhebel" (quick clamping lever).++ Around (Above on the picture) the drill bit is the intake pipe of the vacuum cleaner Make sure that the right drill head is put and fixed inside the drilling machine.Attach and fasten drill head + drill machine:.As of right now, there is no practical solution to this issue aside from opening the doors and trying to look around to see the LEDs. +Inside of the enclosure, the LEDs are not easily visible at the back of the enclosure. It should look like this in order to function properly: +On the left side of the machine you can find LEDs which indicate the status. +For this it should be connected to a power socket and also to the USB port of the MacBook (it’s a white/gray cable). This does not immediately start the drilling process. After this the milling machine can be turned on.+Yes, fixating and moving the downholders can be very hard. +Additionally screws should be tightened into some of the holes of the downholders in order to fixate the material even more (this can be done by hand or via an electric screwdriver). +The metal "downholders" then need to be fixated into the slots on the sides of the milling machine so that they keep both materials down. At first both materials are placed onto the working surface, whereas the sacrificial plate is to be put down first and on top of it the actual working piece material.Open the doors of the enclosure by pulling at one or two rings.Preparation of the 3D model / CNC mill machine path.The following documentation is divided into the following topics: The Stepcraft is suited for milling of 2D and 3D models with materials such as wood or aluminium.
0 Comments
Leave a Reply. |